制動轂擋塵蓋拉深成形過程的有限元數值模擬
更新時間：2008-9-1 15:59:53 文章來源：互聯網 點擊：
wing and the distribution of residual stress and strain after deep drawing in different forming schemes are analyzed. The results show that: for the dust-cover deep drawing, to form the box-part firstly is more beneficial than to form the step-part firstly; the material located slightly lower than the tangent position of the top round corner and straight-wall of the dust-cover is thinned most seriously, this region is the dangerous cross-section where fracture may occur in the deep drawing of dust cover.
文章地址：http://www.www.direxe.cn/Article/mjjs/200809/177.html
文章地址：http://www.www.direxe.cn/Article/mjjs/200809/177.html
- 上一篇文章： 快速成形與快速模具技術的應用
- 下一篇文章： 輕卡頂蓋整形側整形三維模具設計
Copyright(C) 2008-2009 www.direxe.cn,All Rights Reserve
公司地址：上海嘉定區寶嘉公路2328號 | 郵 編：201808 | 傳真：021-39972181
Email:info@www.direxe.cn | [滬ICP備17010041號-1]
公司地址：上海嘉定區寶嘉公路2328號 | 郵 編：201808 | 傳真：021-39972181
Email:info@www.direxe.cn | [滬ICP備17010041號-1]